NEWS

How to clean the shower
1. Pour the vinegar into the basin to the extent that the sprinkler head can be submerged. After soaking in vinegar for about ten minutes, the scale in the shower head can be removed.
2. Wash the water outlet with an old toothbrush, turn on the shower after brushing for a while, and repeat the process until the scale is completely removed.
3. Rinse the shower faucet with clean water, wipe all the water on the metal surface of the faucet with soft cotton cloth, wipe it gently, and do not rub it vigorously. Dry with wet sponge and soft skin to make the surface shiny.

Less sprinkler water
1. Maybe the water pressure becomes smaller. At this time, we can contact the property management company or the water supply company to let them deal with it.
2. A blockage in one part of the hose may also reduce the water output of the sprinkler. It can be replaced or dredged by itself.
3. If the nozzle is blocked, sharp objects can be used to remove sundries. If the scale blockage of the shower is serious, we can directly remove the shower and soak it in the descaling agent, and then clean it carefully. You can also soak the shower head in vinegar and put it for a few hours to remove the scale. The shower is cold and hot. This situation is caused by the unstable water pressure of hot and cold water in the water pipe. There are two solutions, one is to install a booster valve, and the other is to change the constant temperature shower. Constant temperature shower can automatically balance the water pressure of cold water and hot water through the constant temperature regulating valve core of the faucet, so as to maintain the stability of water temperature.

Shower drip
1. The shower nozzle will deposit a lot of impurities after being used for a long time, which will cause dripping. The shower nozzle can be disassembled for cleaning.
2. If it is loose, carefully check where it is loose and tighten the loose parts in time.
3. Most of this situation is caused by the damage of the shower switch valve or the failure to close it after use. If the switch valve is damaged, it is OK to directly re purchase a replacement of the same model. But if you just don't close it tightly, it's a good solution. Just close the switch yourself.

Sprinkler seepage
1. It may be that the water pipe joint and shower are not tightened. This joint is tightened clockwise and loosened counterclockwise, similar to a screw. You can hold the spray with one hand and the joint of the outlet pipe with the other hand to rotate left and right. If there is still water leakage after tightening, continue to check.
2. It may be whether the thread between the spray at the joint and the water pipe is slippery or damaged at the joint. If it cannot be screwed tightly or after it cannot be rotated, the water pipe has not been completely sleeved into the spraying, it is a sliding tooth and sliding wire. The joint damage can be observed carefully. If it belongs to such a problem, you can go to the hardware store to buy a shower for installation.
3. It may be that the sealing gasket is aging. Because the water temperature of the outlet pipe of the water heater is very high, in winter, the frequent high-temperature hot water of 5 and 60 degrees and the frozen water of several degrees can easily make the sealing gasket aging and lose elasticity, and the water pipe will leak. This is the greatest possibility. At this time, replace the new sealing gasket.